Wiring the digital safe

1. Take the back off the door of the safe (usually 3 or 4 screws)
2. Find the solenoid - this is a cylinder (blue in the picture below) which has a bolt inside it which engages with the door locking mechanism, so it's what electronically controls the locking/unlocking of the safe.
3. You'll find 2 wires coming from it to the control board
4. Cut one of them (whichever's longest)
5. Clean about 1cm or 1/2 inch insulation off both ends of the wire
6. Clip the wire into the clips on the end of the white wire coming from the MortiSafe Pro core unit

[Need a picture in here]

1. Screw the panel back onto the safe
2. Put all the parts inside the safe, but don't close the door. You should make sure you're fully familiar with the MortiSafe Pro operation and you have locked/unlocked the safe several times while the safe door is open before you close it

For details of how to operate the safe, see here

For more pictures, see here.