Wiring the digital safe
- Take the back off the door of the safe (usually 3 or 4 screws)
- Find the solenoid - this is a cylinder (blue in the picture below) which has a bolt inside it which engages with the door locking mechanism, so it's what electronically controls the locking/unlocking of the safe.
- You'll find 2 wires coming from it to the control board
- Cut one of them (whichever's longest)
- Clean about 1cm or 1/2 inch insulation off both ends of the wire
- Clip the wire into the clips on the end of the white wire coming from the MortiSafe Pro core unit
[Need a picture in here]
- Screw the panel back onto the safe
- Put all the parts inside the safe, but don't close the door. You should make sure you're fully familiar with the MortiSafe Pro operation and you have locked/unlocked the safe several times while the safe door is open before you close it
For details of how to operate the safe, see here
For more pictures, see here.